Protective materials used include alufom, penotherm, and penofol.
Posted: Mon Feb 17, 2025 10:39 am
Installation of vapor barrier material when insulating inside a brick house
Vapor barrier of brick walls is produced using several types of materials to choose from. Indoors, these are films and membranes.
Materials based on foil are also applicable. They have reflective properties. In this case, the foil side is placed inside the room.
If a brick wall is insulated from the inside with mineral wool, then it must be protected on both sides. On the wall side from condensation, and on the room side from steam penetrating into the insulation.
First of all, the wall is prepared: it is cleaned of gcash data protrusions and dust.
Afterwards, the vapor barrier is fixed, the insulation is placed in the created lathing and the vapor barrier is placed on top again. In this way, the mineral wool is protected on both sides.
Which side to lay on the insulation inside the building: how to lay
Depending on where the material is being installed, it is determined which side it should be laid on:
When laying insulation on the street side, the vapor barrier is fixed to the insulation on the street side.
When processing the ceiling and roof, antioxidant materials are used. They are fixed to the insulation.
If there is no additional fastening of the ceiling and roof insulation, then the material is fastened from below the rafters.
If thermal insulation is applied from the inside of the walls, then fixation is carried out from the outside of the insulation.
Many materials are used that have the same surface on both sides. Therefore, it makes no difference which side the vapor barrier is attached to.
Which side to attach and nail
When the question arises as to which side the vapor barrier is fixed, nuances arise:
Vapor barrier of brick walls is produced using several types of materials to choose from. Indoors, these are films and membranes.
Materials based on foil are also applicable. They have reflective properties. In this case, the foil side is placed inside the room.
If a brick wall is insulated from the inside with mineral wool, then it must be protected on both sides. On the wall side from condensation, and on the room side from steam penetrating into the insulation.
First of all, the wall is prepared: it is cleaned of gcash data protrusions and dust.
Afterwards, the vapor barrier is fixed, the insulation is placed in the created lathing and the vapor barrier is placed on top again. In this way, the mineral wool is protected on both sides.
Which side to lay on the insulation inside the building: how to lay
Depending on where the material is being installed, it is determined which side it should be laid on:
When laying insulation on the street side, the vapor barrier is fixed to the insulation on the street side.
When processing the ceiling and roof, antioxidant materials are used. They are fixed to the insulation.
If there is no additional fastening of the ceiling and roof insulation, then the material is fastened from below the rafters.
If thermal insulation is applied from the inside of the walls, then fixation is carried out from the outside of the insulation.
Many materials are used that have the same surface on both sides. Therefore, it makes no difference which side the vapor barrier is attached to.
Which side to attach and nail
When the question arises as to which side the vapor barrier is fixed, nuances arise: