Important! Most often, the springs and cord fail.

[zihadhosenjm40]

To determine the nature of the breakdown, follow these steps:

Arm yourself with the instructions for the walk-behind tractor and a key to unscrew the nuts with which the starter is attached to the walk-behind tractor.
Disconnect the starter, recording all the steps on paper or using photographs so that when installing it back in place, nothing gets mixed up or missed.
Unscrew the top washer of the starter and disassemble the mechanism.
Inspect the parts for damage.
If a defect is found, replace the part with a new one.

The spring has hooks at the ends that break off over time. Buy a new spring or bend the free end on the damaged one, after which it is ready for use again. The broken cord is replaced with a new one.



How to start without a starter
If the starter breaks down and there is no time or nigeria mobile database to buy a new one, start the walk-behind tractor as follows:

Remove the starting device.
Take a device in the form of a piece of rope or clothesline 1.5-2 meters long.
Thread the cord through the hole on the walk-behind tractor element to which the starter was attached.
Wrap the rope around, leaving a 45cm piece free.
For convenience, you can attach a small handle to the end of the rope, but this is dangerous and can cause damage to the equipment.
To start the engine, pull the rope hard.
If the launch fails, repeat all the steps again.
Keep in mind that this method is dangerous and should only be used in cases of extreme necessity. Do not wrap the rope around your hand so that it does not get pinched by the engine in case of unforeseen circumstances. If it is possible to postpone starting the engine until you buy a new, working starter, wait and start it safely, according to the rules. Otherwise, you do everything at your own risk.