- while maintaining the same pressure further.
Posted: Mon Feb 10, 2025 5:08 am
s, spatulas of 40, 45 and 60 centimeters are used. The putty is applied as evenly as possible, without pressing it too much into the walls.
After the first layer of putty has dried, the second is applied indonesia mobile database a 60-centimeter spatula. The putty is applied and smoothed in two directions, mutually perpendicular to each other. Finally, after preparation, the process of decorating the walls begins, consisting of the following several stages:
1. Dry plaster is mixed with water until a homogeneous consistency is achieved.
2.Then the mixture is applied to the walls in a layer of 2-4 millimeters to proceed to decoration. If it is necessary to level the surface of the walls, the layer is made dense. Everything is smoothed with a spatula.
3. Next, you need to stop the work for about ten minutes to thicken the composition, and then go with a textured roller from top to bottom, forming a pattern. In this case, it is advisable to work in pairs, so that one worker applies the plaster, and the second creates the selected relief.
4. Subsequent treatment of the walls with paint is carried out after 48 hours, that is, after the plaster has completely dried. If you plan to paint the entire wall, you need to buy a roller with a long pile, and in order to add color only to specific protruding elements, a roller with a short pile is used.
Rules for the careful application of decorative plaster
When using textured rollers for decorative plaster, certain rules should be followed:
-You can’t press the roller too hard against the wall; the movements should be slow and smooth.
-Apply the second layer of paint starting at the place where the border of the first strip runs, without overlapping.
After the first layer of putty has dried, the second is applied indonesia mobile database a 60-centimeter spatula. The putty is applied and smoothed in two directions, mutually perpendicular to each other. Finally, after preparation, the process of decorating the walls begins, consisting of the following several stages:
1. Dry plaster is mixed with water until a homogeneous consistency is achieved.
2.Then the mixture is applied to the walls in a layer of 2-4 millimeters to proceed to decoration. If it is necessary to level the surface of the walls, the layer is made dense. Everything is smoothed with a spatula.
3. Next, you need to stop the work for about ten minutes to thicken the composition, and then go with a textured roller from top to bottom, forming a pattern. In this case, it is advisable to work in pairs, so that one worker applies the plaster, and the second creates the selected relief.
4. Subsequent treatment of the walls with paint is carried out after 48 hours, that is, after the plaster has completely dried. If you plan to paint the entire wall, you need to buy a roller with a long pile, and in order to add color only to specific protruding elements, a roller with a short pile is used.
Rules for the careful application of decorative plaster
When using textured rollers for decorative plaster, certain rules should be followed:
-You can’t press the roller too hard against the wall; the movements should be slow and smooth.
-Apply the second layer of paint starting at the place where the border of the first strip runs, without overlapping.