Comfortable rubber handle - comfortable to hold.
Posted: Mon Feb 10, 2025 4:19 am
+ Pros of Inforce 03-12-02
Wide range of temperature selection options, both with toggle switches and a thermostat, from 0 to 300 degrees.
Fast heating of heating elements.
Good capacity of the suitcase.
Comes with a tape measure, screwdriver, pipe cutter and gloves.
All attachments are secured in the case and do not dangle denmark mobile database transportation.
Six dies for pipes with diameters from 20 to 63 mm.
The pipe cutter will do its job perfectly and you won’t need to buy anything extra.
Good surface coverage of the attachments.
— Cons of Inforce 03-12-02
The bulky body makes it difficult to get to the place where you want to close the communication circuit.
It is not the lightest model and the master will quickly get tired when holding it with his hands.
Sometimes you come across nozzles with chips, but this is rare.
The suitcase is flimsy and requires careful handling, otherwise it will quickly become deformed.
The heater is attached to the body via a bracket, and the bolt head prevents the device from being placed on a stand.
When starting, the set temperature of 260 degrees jumps and overheats the fitting, so you first need to set it to 150 degrees and then raise it.
Conclusion. This is the best soldering iron for polypropylene pipes thanks to very high-quality nozzles. The Teflon coating is thick and removes traces of plastic from the matrix for a long time. The device is well suited for frequent use at sites with a large volume of work.
Wide range of temperature selection options, both with toggle switches and a thermostat, from 0 to 300 degrees.
Fast heating of heating elements.
Good capacity of the suitcase.
Comes with a tape measure, screwdriver, pipe cutter and gloves.
All attachments are secured in the case and do not dangle denmark mobile database transportation.
Six dies for pipes with diameters from 20 to 63 mm.
The pipe cutter will do its job perfectly and you won’t need to buy anything extra.
Good surface coverage of the attachments.
— Cons of Inforce 03-12-02
The bulky body makes it difficult to get to the place where you want to close the communication circuit.
It is not the lightest model and the master will quickly get tired when holding it with his hands.
Sometimes you come across nozzles with chips, but this is rare.
The suitcase is flimsy and requires careful handling, otherwise it will quickly become deformed.
The heater is attached to the body via a bracket, and the bolt head prevents the device from being placed on a stand.
When starting, the set temperature of 260 degrees jumps and overheats the fitting, so you first need to set it to 150 degrees and then raise it.
Conclusion. This is the best soldering iron for polypropylene pipes thanks to very high-quality nozzles. The Teflon coating is thick and removes traces of plastic from the matrix for a long time. The device is well suited for frequent use at sites with a large volume of work.