Water heater and autonomous water supply

[zihadhosenjm40]

At this point, the connection to the water supply system can be considered complete. Some experts recommend performing a preliminary check at this stage: fill the container with water, then drain it and check for leaks. This check can only be done after the sealant has completely dried on all connections.

In private households, autonomous rather than centralized water supply is usually used. In such a situation, the use of a storage water heater is entirely justified and possible. But the connection diagram should be slightly modified. In such a case, the water source is usually a tank installed in the attic or upper floor.

This diagram shows the features of connecting russia mobile database storage water heater to an autonomous water supply system if the vertical distance between the heating device and the water tank is less than two meters.

The vertical distance between this tank and the water heater must be measured. If it is less than two meters, a tee is installed at the outlet of the tank to divert some of the cold water to the heating device so that the pipe is above the level at which the heater is installed. A tee with a check valve and a drain branch is installed at the inlet of the cold water pipeline to the device.

If the vertical distance from the water tank to the heater exceeds two meters, the branch is made lower than the heater installation level. In this case, a tee is installed at the cold water inlet to the device with excess water drained into the sewer, and a check valve is connected slightly below.

This diagram demonstrates the option of connecting a storage water heater in a house with an autonomous water supply system, if the vertical distance between the tank and the heater is more than two meters

Before installing the water heater, you should measure the water pressure in the autonomous system of the house. If it exceeds six bars, it is necessary to supplement the installation scheme with a special reducing reducer. Excessively strong water pressure entering the heater can lead to equipment failure.