Calculation of the required amount of materials

[zihadhosenjm40]

cement;
sand;
fine crushed stone.
To carry out work on installing a fence, you will need the following tools:

bayonet shovel;
electric or manual drill;
a cord no less than the total length of the fence;
measuring tape;
building level;
plumb line;
container for preparing the solution;
screwdriver;
electric drill with a set of metal drill bits;
welding machine.
Before you build a fence from corrugated sheets with poland mobile database own hands, you will need to calculate the required amount of material.

When determining the number of sheets of corrugated sheeting, the total length of the fence is divided by the width of one sheet. It should be taken into account that the useful width of the sheet is 1100 mm, while the standard sheet is 1155 mm wide. The overlap of one sheet with another during installation takes 55 mm - the width of one edge.

The length of the sheets depends on the height of the fence. Manufacturers produce sheets of standard sizes (2000 mm, 2500 mm, 3000 mm), but when ordering the material directly from the factory or from an official representative, you can order sheets cut to any size.

This is especially convenient when there are significant differences in height along the fence line and there is a desire to align the top line of the fence at one level, rather than install the sheets in steps.

When calculating the number of screws, you need to proceed from the need for one sheet. Screws are screwed in through one wave on each joist, accordingly, you need to calculate the number of places for installing screws along the width of the sheet, and multiply this number by the number of purlins.