Film heated floor under linoleum:
Posted: Sun Feb 09, 2025 4:24 am
Infrared film installation plan
Important. When installing a heated floor, the electrical wiring capabilities of the room must be taken into account. A heated floor consumes approximately 200 W per square meter of the room, the exact data is available in the instructions provided by the manufacturer. The overall load on electrical networks increases significantly, you need to make sure that the cables and protection fittings can withstand this increase. If the heating power is more than 3 kW, then you need to make separate power wiring.
If not, then you will have to resolve the issue with electricians; sometimes you will need to replace the wiring and protective devices, and get permission from the owners of the electrical networks to increase the capacity.
Installation of the IR film system
Step 3. Choose a place on the wall where you nigeria mobile database to install the thermostat. It should be accessible, the distance to the power source should be minimal. The most optimal is considered to be the area near existing switches or sockets.
Choose a location for the thermostat on the wall
To improve thermal insulation and reduce unproductive losses, a thermal insulator with reflective aluminum foil is placed on the floor base under the thermal film.
Laying foil insulation
The thickness is within 5-6 mm, ready-made rolls with excellent performance characteristics are available. The thermal insulator can be fixed with double-sided tape or staples using a stapler. The joints between the strips must be sealed with tape, the surface must be as airtight as possible.
Important. When installing a heated floor, the electrical wiring capabilities of the room must be taken into account. A heated floor consumes approximately 200 W per square meter of the room, the exact data is available in the instructions provided by the manufacturer. The overall load on electrical networks increases significantly, you need to make sure that the cables and protection fittings can withstand this increase. If the heating power is more than 3 kW, then you need to make separate power wiring.
If not, then you will have to resolve the issue with electricians; sometimes you will need to replace the wiring and protective devices, and get permission from the owners of the electrical networks to increase the capacity.
Installation of the IR film system
Step 3. Choose a place on the wall where you nigeria mobile database to install the thermostat. It should be accessible, the distance to the power source should be minimal. The most optimal is considered to be the area near existing switches or sockets.
Choose a location for the thermostat on the wall
To improve thermal insulation and reduce unproductive losses, a thermal insulator with reflective aluminum foil is placed on the floor base under the thermal film.
Laying foil insulation
The thickness is within 5-6 mm, ready-made rolls with excellent performance characteristics are available. The thermal insulator can be fixed with double-sided tape or staples using a stapler. The joints between the strips must be sealed with tape, the surface must be as airtight as possible.