Wet method
The wet method is more convenient if you are applying it for the first time or with your own hands. Either the adhesive layer or the surface itself is moistened with the solution. This will allow, if necessary, to correctly direct the material when it shifts on the body. All soap solution and bubbles are removed with a squeegee and a hair dryer.
Dry method
This method of application is chosen by specialists who are confident in bahrain mobile database work. It is much faster than the previous one. The material is glued directly to the surface of the body with great precision. With this method of gluing, the vinyl does not need to be dried, which increases the service life of the coating.
Instructions for pasting
By following all the rules, you can quickly and efficiently cover your car with auto vinyl.
If vinyl is chosen for the coating, it is better to cover the entire body, not just partially. This is because it does not let in sunlight, and the car's color will not fade completely. This will be very noticeable after removing the film.
Before the coating itself, it is necessary to carefully prepare the car surface. If there is rust somewhere, this place must be treated and puttied to prevent the spread of metal corrosion.
Conditions for pasting
First, you need to choose a place where the work will take place. This can be a garage with good lighting, the temperature in the room should not be lower than 20 degrees.
Cleanliness is the key to a quality coating. The smallest speck of dust or particle that gets under the film coating will spoil the entire appearance. The work will have to be started over again. Therefore, before starting work, wet the floor surface to prevent dust from flying.